Changzhou Geng Tai Electronics Co., Ltd
Changzhou Geng Tai Electronics Co., Ltd
Add to Cart
DC-DC automatic lifting and pressing solar vehicle constant voltage constant voltage constant current power module
Advantage:
• The circuit board uses a 1.6 thickening gold plating process.
• The replacement of the safety pipe is adopted to protect the power and equipment.
• Full page electrolysis uses imported original patch, low resistance and high frequency capacitance to reduce ripple to freezing point.
• IC imported raw materials;
• Constant voltage, constant current, under voltage protection (MPPT is more suitable for solar charging).
• Output error indicator light, output voltage drift too serious, short circuit and other failures when lighting up;
• The heat dissipation effect of oxidizing fins is better than that of natural aluminum sheets.
• The inductor uses ferric silicon and aluminum, and the heat is smaller.
Electrical parameters (non isolated lift module):
|
1. input voltage: DC5-32V, the recommended voltage should be above 10V.
|
|
2. output voltage: DC1V-30V is continuously adjustable;
|
|
3. output current: 10A (MAX) for a long period of 7A;
|
|
4. output power: long term 80W, peak 130W, over 80W, please strengthen heat dissipation;
|
|
5. output ripple: 50mV (12V to 12V, 5A measured).
|
|
6. input reverse protection: No, if necessary, connect Schottky diode at the input end.
|
|
7. output anti backflow: No, if used for battery charging or load with inductive load, please connect Schottky diode at output end.
|
|
8. size: 77.6*46.5*15mm
9. short circuit protection: there is; |
|
10. weighs about 45 grams; |